Pages

Wednesday, December 06, 2017

Project Journal: Ponte Pants

I don't wear pants very much, but I took a chance on McCall's 6173, and I'm really happy that I did!

This is not me. This is a model who is waaaaay taller than thinner than I ever have been.
Pattern: McCall's 6173, view A-ish, size L, with petite adjustments that were marked on the pattern paper.
Fabric: Telio Ponte Leggero Knit in black 65% Rayon/31% Nylon/4% Spandex. I washed the fabric in cold water and dried it in a low dryer. It sat around a bit before I had a chance to use it, so I also ran it through a steam refresh cycle in my dryer before I cut it out.
Notions: nylon zipper, hook and eye, 1-inch elastic
Tools: Sewing machine with zipper foot, edgejoining foot (for stitch in the ditch) and regular foot. Serger with  Four-Thread Ultra-Stretch Mock Safety Stitch for seams and narrow coverstitch for hems, pressing tools (lots of steam from my iron and a clapper, mostly).
Changes:
- No zippers on the legs.
- I serged the darts and all seams except the fly area and waistband finish. I reinforced the crotch seam with a line of sewing machine stitches within the seam allowance of the serged seam.
- I cut my own waistband and reinforced it with elastic, using techniques from The Busy Woman's Sewing Book. It's all of the comfort of an elastic waistband, but with a tailored look.
- From the same book, I used the two-step fly - a zipper fly with just two lines of stitching! I did have to do the second step over again, after basting a little bit, since it went rather off the rails the first time.
Verdict: On the first wear, these are super-comfy! I hope the fabric holds up well. The legs are much looser in the calf area than in the photo, so if you want a fitted calf, definitely do a basted fitting to check it. This is the most comfortable, best-fitting waistband I've ever worn.

No comments:

Post a Comment